The Platinum In-Wall 3G has one set of terminals for single wiring. Single wiring is achieved by using a single set of cables to the binding posts on the side of the speaker. Internally, the speaker crossover guides the frequencies to the appropriate driver/tweeter: low frequencies to the bass drivers, mid frequencies to the mid/bass driver, and high frequencies to the transducer.
The binding posts are sprung for ease of use and will accept bare wire only.
Press down on each binding post to reveal the through hole and pass the bare wire through the hole. Release the binding post, and it will automatically clamp the cable in place. Ensure there are no loose strands of cables to cause a short circuit.
If you were unable to find an answer to your query in our Platinum 3G support section or you require any further assistance, please contact our technical team via email at technical@monitoraudio.group or give us a call on +44 1268 740580.